How To Wire Wrap A Marble?

How do you wrap a wire around a stone?

To bring the wire to the top of the stone, bend it up on the back of the stone. Start wrapping the top by just bending the wire to the side on the right height and wrapping it around again. Here you can also wrap about three times.

How do you wire wrap stones without holes?

Instructions: How To Wire Wrap Stone Without Holes

  1. Hold the wire from its open end and create a small loop using the looping pliers.
  2. Bend the wire to 90 degrees halfway through the pebble’s length.
  3. When wrapping the wire, keep the wraps even and adjacent, we don’t want too much gaps between the wraps.

What is the best wire for wire wrapping?

The best wire gauge for wrapping stones is the 20-gauge wire. It is neither too hard to bend nor too soft to lose its shape easily.

What do you need to wire wrap crystals?


  1. 15″ piece – 18 gauge copper wire.
  2. Crystal point.
  3. Needle nose pliers.
  4. Round nose pliers.
  5. Wire cutters.
  6. Liver of sulfur (optional)

How do you wire wrap?

To accent the wires themselves, take 1 of the wires and use the pliers to wrap it around 2 of the other wires. Hold the 2 pieces of wire together, and start wrapping them near the base of the pendant. Wrap the wire around the other 2 pieces like a vine until you are satisfied with the look or until you run out of wire.

You might be interested:  How To Faux Marble?

Is a coil a spiral?

As nouns the difference between spiral and coil is that spiral is (geometry) a curve that is the locus of a point that rotates about a fixed point while continuously increasing its distance from that point while coil is something wound in the form of a helix or spiral or coil can be a noise, tumult, bustle, or turmoil.

Leave a Reply

Your email address will not be published. Required fields are marked *